top of page

 MINI JUMP RAMP SPECS

PATENT PENDING

DIMENSIONS:

  • Surface: 8’ Wide X 16’ Long

  • Width front of skirt to front of skirt (14’)

  • Length of surface above water:  (13’)

  • Floating dock 7’6” Wide X 13’ Long

  • Approximately 1,800 lbs

HEIGHT SETTINGS & HEIGHT TO LENGTH RATIOS:

​18”: .115

24”: .154

30”: .194

36”: .234

42”: .269

​​

MiniRamps-website-diagram-v2-13.png

FEATURES:

  • Aluminum frame

  • Fiberglass surface and AlumaCorr skirts

  • Hydraulic Jack for changing height

  • Adjustments all from Kneeler on front

  • Kneeler attached after launch

  • All four anchor ropes accessible

  • Jack and height setting pins accessible

  • Anchor ropes directed more than 2’ underwater at jump frame – no need to worry about boat getting too close

  • Watering system optional (not necessary)

  • Lake towing bridle with attachment points

  • Variable height settings (see below)

Diagrams-14.png

LAKE REQUIREMENTS:

  • 500’ run in (OK if jump or slalom buoys are in this space)

  • 500’ ride out

  • Width all 800’ = 100’

  • Four anchors

    • Set in lake 25’ off each corner at 45 degree angle

    • At least 250 lb.

    • Attachment set in concrete for rope

    • 15’ long rope (prefer rope that won’t float) with plastic or aluminum clip attached to anchor

    • One buoy attached to each anchor rope while ramp not installed

LAUNCH REQUIREMENTS:

  • Once launched, install kneeler with two bolts on each side

  • Attach ropes from jump to anchor ropes, remove buoys

  • Orient jump as desired from kneeler

  • Adjust floating height (tail of jump underwater to marked white lines with sand bag weights attached to the clips welded onto low end of surface frame (if necessary)

NOT PROVIDED:

  • Shipping (can be arranged at buyer cost)

  • Use of an existing available flat bed trailer recommended to minimize cost.

  • Anchors and attached ropes.

  • Watering System (not needed)

bottom of page